FiloSlim injection valve

The injection valve is wrapped under the tape and has a special closure to prevent injected resin from flowing back.

The injection valve’s design enables you to fill the cable joint with either the injection pump or by hand directly from the resin packaging.

Place the resin packaging on the valve and open it with a quarter turn. This manoeuvre anchors the packaging to the valve and creates a leak proof connection.

Once the cable joint is filled, remove the packaging with a reverse quarter turn. This simple action ensures that both the injection valve and the resin packaging are rendered completely leak proof. Thus, any remaining resin in the package has not been exposed to air and can still be used in another cable joint.

PATENTED