FiloSeal+HD

FiloSeal+HD provides a strong support system using the hexagonal tubes which builds up like a honeycomb structure. FiloSeal+HD  is suitable for sealing any cable configuration or pipes contained in one duct and also allows easy re-entry of the seal to add or remove cables or pipes as required

The Filoform duct sealing system FiloSeal+HD uses our MD+ sealant which is easily applied from a skeleton gun. The high quality, one component, flexible sealant “MD+” is based on a silicon compound that cures with air (Humidity).

After application and full curing the thixotropic MD+ forms a plastic elastomer mass with special qualities effectively sealing and bonding, while providing a high level of durability.

FiloSeal+HD is very easy to apply regardless of the type of cable scenario in the cable ducts as it uses strong, but flexible hexagonal tubes to support the cable and provide a strong backing for the seal

The unique design of the hexagonal tubes makes positioning and separation of the cables very simple while also providing a strong backing for the MD+ to be applied on.

• Flexible, one component, adhesive and sealing compound in a cartridge - (310ml)
• High levels of Gas and Water tightness
• Excellent adhesion
• Shows Fire resistance properties
• Resistant against Water, Alkaline, Chemical agents
• Resistant to termites (Mastotermes Darwiniensis) Northern Australian termites
• Resistant to Rats
• Resistant to Hydrogen Sulphide / Methane and many other Gases (NedLab)
• Non corrosive
• Solvent free
• Shock absorbing
• Non toxic, neutral and almost odourless
• Also suitable for limiting the EX-zones during transitions (observe chemical resistance)
• Suitable for any shaped duct / bore hole / opening
• Quick and easy installation
• A complete kit
• Seals common materials (PVC, PILC)
• Suitable for renovations, can be installed retrospectively
• Over 25 years of operational experience

If Fire resistance is required, click here for FiloSeal+HD FIRE

FiloSeal+HD FIRE